Seismic bar allows you to add/delete seismic data sets in the project
For information about the process of loading seismic data into the project, refer to chapter Import seismic
The view consists of 3 sections: Views, Add, Clear.
Views section:
Open predefined seismic data workspace
Workspace: arrow button allows to switch between existing workspaces. Main button of the combobox allows to create a new empty workspace
Add section:
Add dataset - adding single dataset to the project. After adding data it still have to be reviewed and loaded into the project
Add and load dataset - adding and loading a single seismic dataset to the project. After adding data by that operation, it's ready to be used within the project. It assumes that all data is correct as loaded
Load dataset - loading a single seismic dataset that was previously added to the list of project's seismic. It assumes that all needed QC was already done
Load all datasets - loading all seismic datasets that was previously added to the list of project's seismic or were changed during QC process. It assumes that all needed QC was already done on all seismic datasets
Clear section:
Clear dataset - remove a single selected seismic dataset from the project. The application does not deletes data from the disk
Clear all datasets - remove all seismic datasets from the project. The application does not deletes data from the disk
Others section:
Create seismic group
Propagate current shift on whole line
Calculate datum level
Import 3D attributes from ASCII. See more information in Import attributes